Why Do Disc Spring Stacks Lose Preload in Service?
Author: Jenny Xu
Published: Mar 25, 2026
Updated: Mar 25, 2026
Disc spring stacks are often chosen because they can generate high load in a compact space, but preload retention depends on more than the nominal stack calculation. In service, the real system includes friction between washers, support flatness, alignment error, installation surface quality, and the actual operating deflection range.
Preload loss often appears when the stack is arranged correctly on paper but works too close to a settling-sensitive region in practice. Surface flattening, interface wear, coating behavior, or small geometric mismatch in the support hardware can all reduce the retained clamp load over time.
Another common mistake is treating the stack as an isolated spring set instead of part of a bolted or guided system. If the support faces are uneven, the guide clearance is wrong, or the working deflection moves outside the intended window, the stack will not behave like the simplified calculation predicts.
When buyers or engineers review preload drift in disc spring assemblies, the right question is not only whether the washer geometry was correct. The deeper question is whether the stack arrangement and support conditions were validated as a system.
Key Takeaways
- Disc spring preload loss is often a system issue, not just a washer geometry issue.
- Friction, support flatness, settling, and guide conditions strongly affect retained clamp load.
- Stack arrangements must be validated under real support conditions, not only by nominal calculation.