What Tolerances Should Buyers Specify on Custom Spring Drawings?
Author: Jenny Xu
Published: Mar 11, 2026
Updated: Mar 22, 2026
Buyers often inherit spring tolerances from old drawings without checking whether every dimension actually controls function. The result is predictable: unnecessary rejects on dimensions that do not matter, combined with vague requirements on the features that do. A better drawing starts from the question, “which variables control load, assembly, and life in the actual mechanism?”
For compression springs, the most important controls are often load at one or more working heights, free length, outside diameter, solid height, and end condition. For disc springs and wave springs, stack height, thickness window, flatness, or force at a target deflection may matter more than a long list of general dimensions. If the spring must sit in a tight bore or over a shaft, fit-related tolerances become critical; if preload is the core function, force verification usually matters more than cosmetic dimensional precision.
The drawing should also match the inspection method. A tolerance that looks reasonable on paper can create constant disputes if the customer measures under one load condition and the supplier measures under another. Buyers should specify test height, test direction, sample state, and whether presetting or relaxation treatment occurs before inspection. This makes RFQ comparison much cleaner.
The practical rule is simple: tighten only the dimensions that drive function, and define them in the same way both sides will inspect. That reduces quotation noise, lowers scrap risk, and gives the supplier a defensible target for process control.