How to Measure a Spring: A Step-by-Step Guide

Author: Jenny Xu

Published: Nov 10, 2026

Updated: Nov 10, 2026

To measure a spring, record its wire diameter, outside diameter, free length, number of coils, end type and wind direction. Then measure the force at a known length if you can. A caliper is enough for the dimensions, and a force gauge or spring tester gives the rate.

Measuring a compression spring

  • Wire diameter (d): measure at two or three places with a micrometer or caliper, away from ground ends and over bare wire, then average.
  • Outside diameter (OD): measure at the widest point. Mean diameter is D = OD − d.
  • Free length (L₀): stand the spring on a flat surface, unloaded, and measure the overall height.
  • Total coils: count from the tip of the wire at one end to the tip at the other, including partial turns.
  • End type: see whether the end coils are closed against the next coil and whether they are ground flat.

Active coils and solid height follow from the end type:

End typeActive coilsSolid height
Closed and groundTotal − 2Total × d
Closed, not groundTotal − 2(Total + 1) × d
Plain, groundTotal − 1Total × d
Plain, not groundTotal(Total + 1) × d

Measuring an extension spring

  • Wire diameter and outside diameter, as for a compression spring.
  • Length inside the hooks: the distance between the inner faces of the two hooks at rest.
  • Body length and number of body coils.
  • Hook type and the angle between the two hooks.
  • Initial tension: the force at which the coils just begin to separate.

Measuring a torsion spring

  • Wire diameter, outside diameter and number of body coils.
  • Free angle between the legs when unloaded.
  • Leg lengths, measured from the coil axis to the loading point.
  • Wind direction: looking at the end of the spring, right-hand coils move away from you clockwise.
  • Arbor diameter: the shaft the spring runs on. The coil tightens as it winds up, so the arbor needs clearance.

How to measure spring rate and tension

Load the spring to two known lengths in its working range and record both forces. Then k = (F₂ − F₁) / (L₁ − L₂). A fixture with a force gauge gives better results than holding the spring by hand. For an extension spring, subtract the initial tension or use two loaded points. The spring constant guide explains the units, and the calculator estimates the rate from your measurements.

Common measuring mistakes

  • Measuring a used spring as if it were new. A spring that has taken a set is shorter than its original free length.
  • Quoting mean diameter as outside diameter, or the reverse.
  • Measuring over paint or plating when working out the bare wire size.
  • Using total coils in the rate formula instead of active coils.
  • Ignoring whether the spring runs in a bore or over a rod, which decides the OD or ID to control.

What to send for a replacement or quote

Send the measurements above with the material if known, the working loads, the quantity, and photos beside a ruler. A physical sample is better still, since it can be measured and tested. For help with custom compression springs, extension springs or torsion springs, contact Wanjin with your drawing or sample.

Buyer Checklist

  • Wire diameter, averaged over two or three points
  • Outside diameter at the widest point
  • Free length, or length inside hooks
  • Total coils and end type
  • Wind direction for torsion springs
  • Force at two known lengths

Related spring types

Related Posts

Tags