Conical and Barrel Springs: Design, Rate and Solid Height

Author: Jenny Xu

Published: Nov 10, 2026

Updated: Nov 10, 2026

A conical spring is a compression spring whose coil diameter tapers from one end to the other. A barrel spring is largest in the middle, and an hourglass spring is smallest in the middle. Designers use these shapes to shorten solid height, resist buckling, or get a load curve that rises as the spring is compressed.

Conical, barrel and hourglass shapes

ShapeCoil profileMain benefitWatch for
ConicalTapers in one directionCoils can nest for low solid height; wide base resists bucklingHighest stress is in the largest coil
Barrel (convex)Largest in the middleStable under load; small ends fit small seatsMiddle coils bottom first
Hourglass (concave)Smallest in the middleLarge ends seat and centre wellNeeds room at both ends

Why the spring rate changes

Each coil deflects in proportion to the cube of its own diameter, so the largest coils move most. With constant pitch, the largest coils close first. Once a coil bottoms out it stops contributing, the number of active coils falls, and the rate rises. This progressive curve is useful where a soft start and a firm end are wanted. For a near-constant rate, the pitch is varied so that all coils close at about the same time.

Rate formula for a conical spring

Before the first coil bottoms out, a linearly tapered round-wire spring has k = G·d⁴ / (2·Nₐ·(D₁ + D₂)·(D₁² + D₂²)), where D₁ and D₂ are the largest and smallest mean coil diameters. With D₁ = D₂ this reduces to the usual spring constant formula.

Example: carbon spring steel with G = 79,300 N/mm², d = 1.5 mm, D₁ = 24 mm, D₂ = 12 mm and 5 active coils gives k = 79,300 × 1.5⁴ / (2 × 5 × 36 × 720) = 1.55 N/mm. Check stress at the largest coil, because shear stress rises with coil diameter.

Solid height and telescoping

A conical spring can telescope, with each coil sliding inside the next, only if the mean diameter drops by more than two wire diameters per coil. With a 1.5 mm wire that means at least 3 mm per coil, plus clearance. The example above drops 12 mm over 5 coils, or 2.4 mm per coil, so its coils rest partly on one another and it will not fully nest. Fully nested springs can approach a solid height of one or two wire diameters, which is the main reason to choose the shape.

What to put on the drawing

  • Wire diameter and material
  • Largest and smallest outside diameters, and which end seats where
  • Free length and required solid height, stating whether the coils must telescope
  • Total coils, end type and pitch or pitch pattern
  • Force at two or more lengths rather than a single rate
  • Cycle life and operating temperature

Wanjin's compression springs include conical designs within the 0.1–10 mm cold-coiling range. Barrel and hourglass shapes are reviewed case by case. Send a drawing to confirm feasibility.

Key Takeaways

  • With constant pitch, the largest coils close first and the rate rises.
  • Full telescoping needs the mean diameter to drop more than two wire diameters per coil.
  • Specify force at two or more lengths, not a single rate.

Related spring types

Related Posts

Tags