Small Springs and Micro Springs: A Design Guide

Author: Jenny Xu

Published: Nov 10, 2026

Updated: Nov 10, 2026

No standard defines a micro spring. In practice the term covers coil springs wound from very fine wire, often below about 0.5 mm, and small springs with outside diameters of a few millimetres. The same formulas apply as for larger springs, but tolerances, handling and measurement become much harder.

Why small wire is sensitive

Spring rate varies with the fourth power of wire diameter. A 2% change in wire diameter changes the rate by 8%. On 0.2 mm wire, 2% is only 4 µm, so the wire's own tolerance can use up much of a tight force tolerance. For this reason, small springs are usually specified by force at a given length, and the maker adjusts the coils to reach it.

Example: stainless steel with G = 69,000 N/mm², d = 0.3 mm, outside diameter 3 mm so D = 2.7 mm, and 8 active coils gives k = 69,000 × 0.3⁴ / (8 × 2.7³ × 8) = 0.44 N/mm, or 2.5 lbf/in. The spring rate calculator accepts these small dimensions.

Spring index limits

Spring index C is the mean diameter divided by wire diameter. A range of 4 to 12 is the usual target. Below 4, the wire is hard to coil and stress concentrates at the inside of the coil. Above 12, the spring is unstable during coiling, its diameter is hard to hold, and open-ended springs tangle.

Tangling and handling

Small springs with open ends interlock in bulk and can be very hard to feed in automated assembly. Closed ends, a lower index and separated packaging all reduce the problem. If the springs feed through a bowl or a tube, say so on the drawing, because that may change the end design.

Measuring small springs

Calipers can deform a fine spring as they close on it, so optical measurement is the safer way to check diameter and free length. Force should be read on a load cell sized to the job, with test forces well inside its range. The spring measuring guide covers the general method.

Materials and finish

Music wire and stainless steel 302/304 are the usual choices for small coil springs. Phosphor bronze and beryllium copper are used when the spring also carries current, as in contact springs. The spring material guide compares them. Plating thickness is a larger share of a fine wire's diameter, and high-strength steel that is electroplated needs baking to reduce the risk of hydrogen embrittlement.

What to put on the drawing

  • Wire diameter and material
  • Outside or inside diameter, controlling only the one that matters
  • Free length, and force at one or two lengths with tolerance
  • End type and total coils
  • Finish and any cleanliness requirement
  • Packaging and how the springs are fed into assembly

Wanjin's cold coiling range starts at 0.1 mm wire. Send a drawing or sample to confirm feasibility for your size and tolerance.

Key Takeaways

  • Rate varies with wire diameter to the fourth power, so a 2% wire change moves the rate 8%.
  • Aim for a spring index of 4 to 12.
  • Specify small springs by force at a length, and say how they feed into assembly.

Related spring types

Related Posts

Tags